- Com5 putty download install#
- Com5 putty download serial#
- Com5 putty download full#
- Com5 putty download software#
- Com5 putty download code#
With the tempsensor project are you getting feedback on the pc? Any ideas? I'd appreciate your (and anybody's) help. This app is similar to that on the tachometer Forum thread you had back-and-forth with huzbum-and also some other PWM-related posts. I'm now using my new Tektronix DMM with LabView SignalExpress for PC/DMM communication and as a "poor man's" O'scope for rpm data anaysis. Never did figure that one out, since it always said there was no source, I think it was some baud or protocolor old-age mis-match. I don't like my Hyperterminal with its built-in COM3 set-up.) I had a similar problem with connecting a vintage DMM through a Prolific cable. I've run out of ideas on this one and will try other terminal programs (e.g., python, Realterminal, etc. As is common with these things, the most frustrating is that it worked before, so with all I did to bring it back to that virgin "state"-nothing. Bottom line: it's likely a PC (WindowsXP)problem fighting some incompatability bug with PuTTy. I've programmed and reprogrammed the mcu (pristine tempsensor and Make files) without a hitch, so PC/mcu back-and-forth communication seems OK.
Com5 putty download software#
As such, I've removed and reloaded all the communication-related software and drivers,scrubbed the OS and registers, boot/reboot endlessly, same result. I've been there since 4-bit Basic and DOS. You're also right about the vagaries of Windows OS's. That and the "one" data bits are the result of some 2-am redeye typos. Whassup!?Ĭan you use the command line (cmd.exe) to program your mcu using com5?Īnd of course reboot, unplug the USB cable, disable and enable the com port, reboot and reboot again, it is Windose you are using so don't expect to much from it.
Com5 putty download serial#
Yes, I set Serial 115200, one, none, none and used the same Port5 that I used for programming and admin-ID'd myself. After I (succesfully) reprogrammed a 168, It absolutely will not open again. Thanks, Humberto, but it still won't open COM2, even running as administrator. Try opening up Putty as an administrator (right click the icon an open as administrator). So, I have a solutions, but I'd rather just use Putty since I use it for ssh daily. I did download Termite 2.9, gave it the same settings, and it works fine. I mean: no window pops up when I click on the Open button while trying to connect to the COM2 port. No window pops up when I click on the Open button. When I use Putty for ssh, and I click on Open, a windows pops-up with a black background for the shell commands. I've disconnected and reconnected the Nerdkit's USB cable and still unable to open COM2 with Putty.ĭo you have an active serial data feed for putty to display?
Com5 putty download code#
I have no problem running "make" on the USB Nerdkit's initialload project, and the code downloads fine on COM2. I press the Open button on Putty and it does nothing. I am trying to open Putty on COM2 using: speed=115200, data bits=8, stop bits=1, parity=none, flow control=none. For example below "Q1" in a general enquiry for the UPS status.My Nerdkit is connected via USB to COM2 on my Windows 7 laptop.
Com5 putty download full#
The full protocol is a confidential document.
Actually the NMC card is waiting for password, but you might press enter to see the promt.